Hello and welcome to justanswer!

This code is triggered when the oxygen sensor on bank 1, sensor 1 detects a consistently rich fuel mixture.

Driving around yesterday and the check engine cel popped up on the evic.

It's a 2016 ram 2500 6. 4 liter and 6 speed 66rfe transmission.

Inadequate transmission control output voltage can also cause dtcs p0846, p0869, p0871, p0876 or p0988 to set.

That could be the p0841 or another transmission.

Mine either happens when pulling a trailer and getting.

Recommended for you

Just came off the highway previously.

Back in march, i started experiencing shifting problems and it popped a code for the p0871,.

This bulletin involves replacing the transmission solenoid/pressure switch.

The p0700 is telling you the transmission control module or tcm has detected and stored a transmission fault code.

Hi, i'm getting these codes on my dodge durango 2009 (p0846, p0988, p0871, p0876), i recently changed the battery, the transmission fluid is kind of in a bad condition but.

How to fix the dtc p0871 dodge?

While pulling my toy hauler (about 8k lbs empty and almost 16k fully loaded) last week i got the dreaded p0871 code.

Click to display a list of tools used in this procedure.

P0841 is for the low/reverse pressure switch in the solenoid pack mounted on the front of the.

For the '04 dodge intrepid, dtc p0871 indicates od pressure switch sense circuit.

The possible causes for this dtc to set are :

You should have 6.

This could mean that there is too much pressure inside of the transmission or.

Report a problem with this article.

The following tsbs of dodge are related to dtc p0871.

This is a block of data that gets written into memory in the pcm whenever a trans fault is set (and shows what was happening at the moment the fault set).

If you’re experiencing the p0871 code in your dodge ram 2500, it’s important to evaluate the severity of the issue before deciding whether to seek professional help.

The output is commanded on, the dtc will set.

I’m trying to keep from throwing parts at it.

For a complete wiring diagram, refer.

P0871 is an od pressure switch rationality code, and is typically caused by either a worn solenoid switch valve (ssv) bore in the main valve body, or by a bad wiring.

P0871 is an od pressure switch rationality fault, which means the od pressure switch was in the wrong state (open when it should be closed, or closed when it should be.

I spoke with a local transmission shop and was told that.

Related relay dtc's present.

Mil illumination for dtc's p0750, p0755, p0760, p0765, p0846, p0871 or p0841 overview:

Ensure to check for.

On climbing a small grade,.

2004 dodge dakota electrical.

You may also like

I’ve read posts about the p0871 code but i can’t seem to find one with the fix.

Your dodge coronet engine control system detects a problem, the computer stores the diagnostic trouble code p0871 in its memory.

In some cases, the.

How many miles on your truck?

If 90k+, then you likely have a worn solenoid switch valve.

P0871 is an od pressure switch rationality fault, which means the od pressure switch was in the wrong state (open when it should be closed, or closed when it should be open).

Review the 'possible causes' mentioned above and visually examine the corresponding wiring harness and connectors.

Answered in 5 minutes by:

To figure out what is wrong with your vehicle you must first.